Rank: Member
Groups: Member
Joined: 9/2/2008(UTC)
Posts: 53
Location: Sydney, Australia
|
I would like to order the Trident Combo for Buffalo-II (v3) but realise that in the v3 version the R4 resistor is pre-installed. I currently use the old trident where I have changed the resistor on my DVCC trident to allow for more current to power my USB device. Brian, is it possible for you to install a different resistor that will give the DVCC about 20ma more juice if I specify it in the comments of my order?
Alternatively I believe there are thru-holes in the v3 trident so I can just install the appropriate resistor in parallel using these pads?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Paralleling a TH resistor with the installed SMT woudl be the way to go if you want to increase current.
On the 3.3V units, the installed R4 is 20R.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 9/2/2008(UTC)
Posts: 53
Location: Sydney, Australia
|
Thanks Brian! A trident order is on its way.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
