Rank: Member
Groups: Member
Joined: 5/24/2012(UTC) Posts: 40  Location: SW WA state Thanks: 12 times
|
I see the Ivy dual-mono wiring diagram shows the balanced output ground connection landing at the ground connection between R_IN2_+ and R_IN2_- connections. (for both channels) Is it critical where you tie this output ground to on Legato? Maybe it was done this way for the IVY board because it was a closer point? /Mike Edited by user Tuesday, June 26, 2012 2:46:47 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Not sure exactly what you are asking. You would just wire one of the GNDs and both the SE outs. Which one of the GND won't matter as they are joined. Edited by user Tuesday, June 26, 2012 11:30:48 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/24/2012(UTC) Posts: 40 Location: SW WA state Thanks: 12 times
|
Thanks, Russ. I went by the .pdf drawing 'dualmono_BIIandIVYIII.pdf'.
I landed the ground wire for the balanced outs on the bottom of
Legato on center ground post for the riser for the Buffalo between
R_IN2_+ and R_IN2_- . I was afraid to deviate from the drawing without
knowing for sure.
/Mike
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
That will work just fine, don't sweat it.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/24/2012(UTC) Posts: 40 Location: SW WA state Thanks: 12 times
|
Thanks Russ. The ground plane is the ground plane.
/Mike
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
