Rank: Member
Groups: Member
Joined: 2/10/2011(UTC)
Posts: 22
Location: France
|
Hi, Here is my setup: 2 x Buffalo & Legato 3.0 used in Stereo and SE Output 2 x Bipolar Power Supply / one for each Legato 1 x Power Supply for 2 Buffalo's DACs. One multi-channel amplifier for bi-amping.  When the 2 Legatos are connected to the amp there is a noise, and disappear when only one Legato is connected. Wiring analogue power supply ground together only reduce the noise - same for wiring analogue output ground. What is your suggestion ? Best Regards, Alex. Edited by user 13 years ago
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 6/17/2008(UTC) Posts: 921  Thanks: 1 times
Was thanked: 70 time(s) in 69 post(s)
|
Alex, what are you doing there ? Driving two Placid (DP+HD) with only one tranny ? That's a no-go. Edited by user 13 years ago
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 2/10/2011(UTC)
Posts: 22
Location: France
|
Yes AVR300, but an "oversized" 30VA. A transformer with a 12-15VAC secondary rated at 15VA is enough for one Placid HD. I tried to use it with an additional tranny and It works well. No more noise... Thanks AVR300. Edited by user 13 years ago
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 6/17/2008(UTC) Posts: 921 Thanks: 1 times
Was thanked: 70 time(s) in 69 post(s)
|
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
