Twisted Pear Audio Support
»
Product Support
»
Digital
»
Buffalo DAC
»
B3_SPDIF_4 Correct resistors for AES/EBU input?
Rank: Member
Groups: Member
Joined: 1/23/2012(UTC) Posts: 55 Location: central North Carolina
Thanks: 2 times Was thanked: 1 time(s) in 1 post(s)
|
On page 15 of Leon's very helpful(Thanks, Leon!)"Buffalo III DAC Integration Guide" it states that the correct reistors for AES/EBU (<7V) input are R<z> = 56R and RS<z> = 47R. I didn't receive reisistors of these values in the kit. Instead, I received resistor values of 68R and 43R. Out of an abundance of caution, before I solder the resistors I received into the circuit board, is it correct to substitute a 68R resistor for a 56R resistor, and a 43R resistor for a 47R resistor?
Thanks!:d/
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA
Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)
|
I changed the values in the kits to be closer to the desired 110R termination impedance. Both values will work fine, however.
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/23/2012(UTC) Posts: 55 Location: central North Carolina
Thanks: 2 times Was thanked: 1 time(s) in 1 post(s)
|
Brian, thanks for your prompt reply, and confirmation that the R values are correct.
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/23/2010(UTC) Posts: 708 Location: Netherlands
Thanks: 2 times Was thanked: 48 time(s) in 45 post(s)
|
Does this change also apply to the single S/PDIF level converter?
|
|
|
|
Twisted Pear Audio Support
»
Product Support
»
Digital
»
Buffalo DAC
»
B3_SPDIF_4 Correct resistors for AES/EBU input?
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.