Rank: Member
Groups: Member
Joined: 7/13/2007(UTC)
Posts: 27
Location: Tacoma, WA
|
I am going to have 2 coax spdif (2-wire) inputs to the OPUS. Since I have one spdif receiver and one OTTO...
Can i use the OTTO to switch the 2 2-wire inputs by connecting them to say input1 (1 and 2) and input2 (1 and 2)? Then output from output 1 and 2 to the spdif receiver? Would there be any problems doing this that you can think of?
Thank you
Darren
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
That should work fine. Adding a 75R resistor between 1 and 2 on each input (terminator) couldn't hurt, but is probably not needed.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
