Rank: Member
Groups: Member
Joined: 9/15/2011(UTC)
Posts: 25
Location: NZ
Thanks: 1 times
|
Hi folks
I'd like to build a dual placid bipolar ps for an orion crossover. This will be set to 12V and 150mA each side.
I've made a few things successfully and can follow a recipe. I can use a soldering iron and a multimeter. But I dont understand electronics.
I've looked at the manual and think I'm up to the job, however I don't get how to wire up the outputs.
The schematic shows
TP_OUT+
TP_SHUNT+
OUT3
OUT2
OUT1
TP_SHUNT-
TP_OUT-
It look like
+v is obtained across TP_OUT+ and OUT3
-V - is obtained across TP_OUT- and OUT1
What do you do with the TP_OUT2 TP_SHUNT+ and TP_SHUNT- ?
It might be worth adding this into the manual for keen but fledgling DIYers.
Help please anyone?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 10/11/2010(UTC)
Posts: 6
Location: London, UK
|
Hi Bill - I haven't actually built a Placid, but I did scan the manual a while ago as at some stage I'm planning to do the same for my Orion ASP/XO. I think 'TP' refers to 'test point' - i.e. that's where you stick the probes of the multi-meter when you're going through the various stages of the set up procedure. All the best, Gordon Edited by user Friday, September 16, 2011 3:11:58 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
